Honda Acura Civic CRX Integra D16A8 D16A9 D16Z5 DOHC ZC B18A IACV EACV

Honda PP4 PM7 Electronic Idle Air Control Valve
Honda PP4 PM7 Electronic Idle Air Control Valve
Item# 36450-PP4-E01
Availability: Contact us for availability.

Product Description

This is a sale for a brand new genuine Honda Acura Civic CRX Integra Idle Air Control Valve IACV or Electric Air Control Valve EACV from Honda Motors, made by Denso in Japan. Honda part number is 36450-PP4-E01. It will fit 86-91 Honda Acura Integra D16A1 B18A, 88-91 Honda Civic CRX Si D16A6 D16A7 D16A8 D16A9 D16Z5 DOHC ZC. It will also fit other Honda Acura applications. Please email us when uncertain regarding your application.

The IACV is an integral part of the idle control system. It changes the amount of air bypassing the throttle body in response to a current signal from the ECU in order to maintain proper idle speed. After the engine starts, the IACV opens for a certain time. The amount of air is increased to raise the idle speed about 150-300 rpm. When coolant temperature is low, the IACV is opened to obtain the proper fast idle speed. The amount of bypassed air is also controlled in relation to the coolant temperature.

When Check Engine light is on. With the service connector jumped, CODE 14 is indicated. It is highly likely a fault relating with the IACV.

The IACV is a component whereby when faulty is the most probable cause to most idle-linked problems. The problem can be symptomatic and may not even trigger the Check Engine light. The list goes:

  1. When cold fast idle out of spec (1,000 - 2,000 rpm)
  2. Rough idle
  3. When warm RPM too high
  4. Idle speed is below specified rpm (no load)
  5. Idle speed does not increase after initial start up
  6. On models with automatic transmission, the idle speed drops in gear
  7. Idle speed drops when air conditioner is ON
  8. Idle speed drops when steering wheel is turning
  9. Idle speed fluctuates with electrical load
  10. Frequent stalling while warming up
  11. Frequent stalling after warming up

When the two terminals on the IACV are measured with an Ohm-meter, it must vary between 8-15 Ohms. If not, the IACV must be replaced.

Buyers are to make sure the other sub-systems or ECU are working well before making their own conclusions.

Buyers are welcome to email me for installation instructions.

Shop with confidence. Try our secure on-line shop.

If you have any questions regarding any product, shipping or a placed order, please email us at:

We will get back to you as soon as we can.

Thanks for looking.