Honda Accord Prelude F22A F22B H23A OBD0 OBD1 IACV EACV

This is a sale for a brand new genuine Honda Accord Prelude Idle Air Control Valve IACV or Electronic Air Control Valve EACV from Honda Motors, TEC/Denso Japan. They can be easily installed on Honda Accord and Prelude OBD0 and OBD1 air intake manifolds; located at the front of the manifold dashpot. Fitment includes JDM F20A & F22B, B20A, B21A & F22A series such as 90-93 Honda Accord F22A, 88-91 Honda Prelude Si B20A B21A & 92-96 Honda Prelude Si/SE H23A & JDM F22B DOHC. Please make your own checks and email us when uncertain regarding your application.

The IACV is an integral part of the idle control system. It changes the amount of air bypassing the throttle body in response to a current signal from the ECU in order to maintain proper idle speed. After the engine starts, the IACV opens for a certain time. The amount of air is increased to raise the idle speed about 150-300 rpm. When coolant temperature is low, the IACV is opened to obtain the proper fast idle speed. The amount of bypassed air is also controlled in relation to the coolant temperature.

When Check Engine light is on. With the service connector jumped, CODE 14 is indicated. It is highly likely a fault relating with the IACV.

The IACV is a component whereby when faulty is the most probable cause to most idle-linked problems. The problem can be symptomatic and may not even trigger the Check Engine light. The list goes:

1. When cold fast idle out of spec (1,000 - 2,000 rpm)
2. Rough idle
3. When warm RPM too high
4. Idle speed is below specified rpm (no load)
5. Idle speed does not increase after initial start up
6. On models with automatic transmission, the idle speed drops in gear
7. Idle speed drops when air conditioner is ON
8. Idle speed drops when steering wheel is turning
9. Idle speed fluctuates with electrical load
10. Frequent stalling while warming up
11. Frequent stalling after warming up

When the two terminals on the IACV are measured with an Ohm-meter, it must vary between 8-15 Ohms. If not, the IACV must be replaced.

Buyers are to make sure the other sub-systems or ECU are working well before making their own conclusions.

Buyers are welcome to email me for installation instructions.