Honda Acura Distributor Igniter Ignition Module ICM

This is a sale for a brand new genuine Honda Acura OBD0 OBD1 OBD2 NEC / Elesys Model MC-8132 Igniter Control Module Set from Honda Motors, Japan. It can be installed on many Honda, Acura OBD0, OBD1 and OBD2 Distributors, VTEC or non-VTEC. The applications are very wide. Please e-mail us when uncertain and make your own checks regarding your application. Buyers are advised to check their present ICM brand in their present distributors if uncertain.

Other brands new igniter control module are available including OKI & Hitachi, subject to availability.

To prevent premature failures, it is important to fit the igniter control module properly so as to ensure proper heat transfer and prevent excessive vibration.

The obvious symptom of a faulty igniter control module is after several futile attempts to start the engine and prolonged cranking, Check Engine light turns on. With the service connector jumped, CODE 15 is indicated. It is highly likely a fault relating with the ignition output signal/igniter module. (It may take about 20 seconds of cranking to set off the code)

A faulty igniter module also gives the same hot hard starting symptoms as a faulty main relay. The difference is that for the igniter module, the fuel pump can be heard working after the ignition is turned on, simultaneously the check engine light lights up for about 2 seconds. The other symptoms includes erratic movement of the tachometer needle when the engine is operating and sudden stalling of the engine.

Potential buyers are to make sure the other sub-systems or ECU are working well before making their own conclusions.

The igniter control module includes two holding compound coated screws and instruction leaflet.